Passenger Side Rear Quarter Panel

Now its time to work on the passenger side.  Before starting into this, I noted that the car door already didn't match up very well to the quarter panel.  So - I used my camera to document where the quarter was high/low and where it lined up correctly.

Once documented, it was time to start cutting metal out of the rear quarter panel.

 

 

 

 

And the first panel mock-in...

 

 

Cleco time part 2!

 

And now time to weld it in.

 

 

 

Now that its welded in, I ground down the welds and sprayed them with primer to keep any premature rusting.  You can tell there is a seam there, but hopefully once I'm in the bodywork phase I will be able to successfully hide the seam. (we'll see on that one)

 

 

 

Next step on deck - having baby #3 and then we'll see where things go after that!